TITLE 35: ENVIRONMENTAL PROTECTION
SUBTITLE B: AIR POLLUTION
CHAPTER I: POLLUTION CONTROL BOARD
SUBCHAPTER c: EMISSIONS STANDARDS AND LIMITATIONS FOR STATIONARY SOURCES
PART 219 ORGANIC MATERIAL EMISSION STANDARDS AND LIMITATIONS FOR THE METRO EAST AREA
SECTION 219.441 PETROLEUM REFINERY WASTE GAS DISPOSAL


 

Section 219.441  Petroleum Refinery Waste Gas Disposal

 

a)         Except as provided in subsection (b) or (c) of this Section, no person shall cause or allow the discharge of organic materials in excess of 100 ppm equivalent methane (molecular weight 16.0) into the atmosphere from:

 

1)         Any catalyst regenerator of a petroleum cracking system; or

 

2)         Any petroleum fluid coker; or

 

3)         Any other waste gas stream from any petroleum or petrochemical manufacturing process.

 

b)         Exception.  Existing sources subject to subsection (a)(3) of this Section may, alternatively, at their election, comply with the organic material emission limitations imposed by 35 Ill. Adm. Code 219.301 or 219.302; provided, however, that there shall be no increase in emissions from such sources above the level of emissions in existence on May 3, 1979.

 

c)         New Sources.  Sources subject to subsection (a)(3) of this Section, construction of which commenced on or after January 1, 1977, may, at their election, comply with the following emission limitations:

 

1)         A maximum of eight pounds per hour of organic material; or

 

2)         Emission of organic material in excess of the limitation of subsection (c)(1) of this Section is allowable if such emissions are controlled  by air pollution control methods or equipment approved by the Agency capable of reducing by 85 percent or more the uncontrolled organic material that would otherwise be emitted to the atmosphere.  Such methods or equipment must be approved by the Agency and approved by the USEPA as a SIP revision.

 

(Source:  Amended at 17 Ill. Reg. 16918, effective September 27, 1993)